Epson DLQ-3500 Quick Manual page 5

Auto I/F (interface) wait time
When the printer is in the auto interface
mode and it receives no data from the
currently selected interface for the amount
of time specified with this setting, it
determines which interface is receiving data
and switches to that interface. You can
specify either 10 seconds or 30 seconds for
the auto interface wait time.
Parallel I/F bidirectional mode
The Parallel Interface bidirectional transfer
mode is used when this feature is on. If
bidirectional transfer mode is unnecessary,
turn this off.
Packet mode
Be sure to select Auto when printing from
Windows applications using the printer
driver included in the CD-ROM that comes
with the printer. In case you encounter any
communication troubles when printing
from applications based on other operating
systems such as DOS, turn off this mode.
Auto CR (carriage return)
This setting is available only in IBM PPDS
emulation mode. When auto carriage return
is on, each line feed (LF) code or ESC J code
is accompanied by a carriage return (CR)
code so the printer moves the next printing
position to the left margin. When this setting
is off, you must send a CR code after the line
feed code to move the printing position to
the left margin.
A.G.M. (IBM)
Turn on the alternate graphic mode (A.G.M.)
to make the ESC 3, ESC A, ESC J, ESC K, ESC
L, ESC Y, ESC Z, and ESC * commands in
IBM PPDS emulation mode work the same
way as in ESC/P 2 mode.
EPSON DLQ-3500 Quick Guide
The A.G.M. feature is available only in IBM
PPDS emulation mode.
Character table
You can select from among 13 to 36 standard
character tables, depending on the country
of purchase. See "Default-setting mode" for
more information.
International character set for italic table
You can select among several international
character sets for the italic character table.
Each character set contains eight characters
that vary depending on the country or
language, so you can customize the italic
table to suit your printing needs.
Font
One of these fonts selected in the default
setting is corresponding to Others on the
control panel. You can select the following
fonts directly on the control panel: Draft,
Roman, Sans Serif, Courier, Prestige and
Script.
Manual feed wait time
This setting allows you to set the amount of
wait time between when paper is inserted
into the paper guide and it is fed. If the paper
feeds before you can adjust its position
properly, you should increase the wait time.
Buzzer (beeper)
The printer beeps when an error occurs. See
"Error Indicators" for more information on
printer errors. If you do not want the printer
to beep when an error occurs, turn off this
setting.
Default Settings (3/4)