Epson DLQ-3500 Quick Manual page 17

6. Insert the paper along the right paper
guide and adjust the position of the left
paper guide so that it matches your
paper's width. Make sure the position of
the guide allows the paper to move up
and down freely. Then lock the left guide
in place.
Note:
Load paper with the printable side up. If you
are using pre-printed forms, load the forms
top-down.
7. Push back the paper set levers to clamp
the paper against the guide rollers.
8. Before printing, make sure that
Manual/CSF is selected as the paper
source on the control panel. If not, select
it by pressing the Paper Source button.
Also set the paper-thickness lever to the
appropriate position for the paper
loaded in the cut-sheet feeder as
described in "Paper-Thickness
Settings." In your printer driver
software, select your paper size from the
Paper Size list.
EPSON DLQ-3500 Quick Guide
The cut-sheet feeder feeds paper when
you send data to the printer. You can also
feed paper by pressing the Load/Eject
button.
Note:
❏ If the platen turns without loading the paper,
completely remove the paper and then insert
it all the way into the printer again.
❏ If you need to adjust the position of the paper
after it is loaded, see "Adjusting the
top-of-form position" and follow the
instructions.
Loading paper manually using the
front paper guide
The cut-sheet feeder's single-sheet loading
feature allows you to switch to a different
type or size of paper without replacing the
paper already loaded in the cut-sheet feeder
or removing the feeder.
Follow these steps to load paper manually
using the paper guide:
1. Make sure that Manual/CSF is selected
as the paper source on the control panel.
If not, select it by pressing the Paper
Source button.
2. Push the paper guide and the paper
guide extension all the way in.
3. Adjust the edge guide so that it is aligned
with the guide mark on the paper guide.
4. While aligning the left side of paper with
the edge guide, insert it until it meets
resistance. Be sure to load paper
printable side up. After a few seconds,
the printer automatically advances the
paper to the loading position. The
printer is ready to accept data from your
computer and print.
Single Sheets with the Cut-Sheet Feeder (2/3)