Epson DLQ-3500 Quick Manual page 16

Single Sheets with the Cut-Sheet Feeder
Loading paper to the cut-sheet
feeder
For single-sheet multipart forms, use only
the type of forms that are glued at the top.
To avoid paper jams, do not allow too many
printed sheets to be stacked on the paper
guide at one time. Remove the stack when it
is half as thick as the paper loading limit
marked on the cut-sheet feeder.
Follow these steps to load paper to the
cut-sheet feeder:
1. Pull the paper set lever forward until the
paper guides retract to allow paper
loading.
2. Release the paper guide lock levers by
pulling them forward.
EPSON DLQ-3500 Quick Guide
3. Slide the right paper guide so that its
edge is even with the guide mark on the
cut-sheet feeder and push back the lever
to lock the paper guide in place. Next,
slide the left paper guide to roughly
match the width of the paper.
4. Slide the center support midway
between the paper guides.
5. Fan a stack of paper, and tap the sides
and bottom of the stack on a flat surface
to even it up.
c
Caution:
Do not load labels to the cut-sheet
feeder.
Single Sheets with the Cut-Sheet Feeder (1/3)