Table of Contents
Advertisement
Figure 60
1. Roll bar in the upright
position
2. Roll-bar knob in the
latched position
3. Pull the roll-bar knob out
and rotate it 90 degrees.
Figure 61
1. Engaged
g228804
4. Rotate the roll-bar knob 90
degrees.
5. Roll-bar knob in the
unlatched position
6. Roll bar in the folded
position
g228981
2. Partially engaged—do not
operate with the roll bar in
this position.
Adjusting the Tracking
1.
Disengage the blade-control switch (PTO).
2.
Drive to an open flat area, move the
motion-control levers to the N
position.
3.
Move the throttle midway between fast and slow.
4.
Move both motion-control levers all the way
forward until they both hit the stops in the T-slot.
5.
Check which way the machine tracks.
•
If it tracks to the right, loosen the bolts and
adjust the left stop plate rearward on the
left T-slot until the machine tracks straight
(Figure
62).
•
If it tracks to the left, loosen the bolts and
adjust the right stop plate rearward on the
right T-slot until the machine tracks straight
(Figure
62).
6.
Tighten the stop plate
Left control lever shown
1. Control lever
2. Bolt
45
-L
EUTRAL
(Figure
62).
Figure 62
3. Stop plate
OCK
g010153
Advertisement
Table of Contents
