Ariens Zoom 2552XL Operator's Manual page 19

8. Replace long mower belt on mower clutch sheave. See
Replacing Mower Belts on page 18.
5
3
4
1. Hydro Belt
2. Spring
3. Idler
4. Engine Sheave
MOWER DECKS
Adjusting Anti-Scalp Rollers
The anti-scalp rollers are set at the factory for typical
mowing height, but can be adjusted for high or low cutting
conditions (Figure 18).
Rollers are intended to prevent lawn scalping, not to control
cutting height.
For a very high cutting height, set the rollers in their lowest
position on the bracket.
For a very low cutting height, set the rollers in their highest
position on the bracket.
All rollers should be set at the same height.
Figure 18
1
7
8
5. Right Hand Hydrostat
6. Left Hand Hydrostat
7. Clutch
8. Clutch Anchor
Figure 17
Lowest
Cutting
Height
Highest
Cutting
Height
Removing the Mower Deck
1. Remove PTO (long) mower belt (See Replacing Mower
Belts on page 18).
2. Remove link chains from mower lift arms. Note hole
6
location on mower lift arms for replacement.
3. Remove mower mounting arms from frame.
4. Slide mower deck out from under unit.
2
4
OF1631
1. Mower Lift Arm
2. Link Chain
Installing the Mower Deck (Figure 19)
1. Slide mower deck under unit.
2. Install mower mounting arms on frame.
3. Install link chains on the mower lift arms in the same
holes they were removed from.
4. Install PTO (long) mower belt (See Replacing Mower
Belts on page 18).
5. Level mower deck (See Leveling the Mower Deck on
page 20)
OF3161
GB - 19
1
1
3
2
3. Mower Mounting Arm
4. PTO (Long) Mower
Belt
Figure 19
2
Of0316