Ariens Zoom 2552XL Operator's Manual page 10

Mower Lift Lever
Use the mower lift lever, located on the left
side of tractor, to raise and lower the mower
deck.
Pull the lever rearward to raise or push the
lever forward to lower the mower deck.
Release lever to hold the mower deck in
selected position.
The cutting height indicator on the right lift
cylinder shows the approximate cutting
OF1700
height in inches.
Cylinder Stops
The cylinder stops ensure the same cutting height after
raising the deck to clear an obstacle. Store the stops on the
post behind the hydraulic lift cylinder. The stops come in two
(2) sizes, 1/4 in. (.64 cm) and 1/2 in. (1.27 cm).
1. Remove the cylinder stops from the post and snap
onto the lift cylinder rod.
2. Push the lift lever forward until the cylinder rests
against the cylinder stops.
Fuel Shut-Off Valve
Use this valve to control fuel flow from left
OFF LEFT
or right fuel tank.
TANK
Open the valve to operate the engine. Turn
RIGHT
TANK
the valve to Off when storing or transporting
OF1881
the unit.
Parking Brake Lever
1. Pull lever up to engage parking brake.
2. Push lever down to disengage parking
brake.
OF1740
Seat Adjustments
WARNING: Make all seat adjustments with unit
stationary, parking brake on and engine shut off.
To adjust seat forward or backward:
1. While seated, pull seat adjustment lever outward and
slide seat into desired position.
2. Release lever and slide seat forward or back to lock
seat into position.
Engine Oil Pressure Indicator
Indicator lights up Red if the oil pressure is
low. Check oil level and add if necessary.
Refer to engine manual.
OG0601
Hour Meter
Records total number of hours the engine
has been run.
IMPORTANT: Keep a record of Hour Meter
readings for recommended Lubrication and
Maintenance intervals.
NOTE: For accurate readings be sure Ignition Switch is OFF
when unit is not in operation.
FILLING FUEL TANK
WARNING: AVOID INJURY. Read and understand
entire Safety section before proceeding.
Add fuel to Fuel Tank as needed. See your Engine Manual
for correct type and grade of fuel.
To add fuel to the fuel tank:
1. Place unit in an open or well-ventilated open area.
2. Stop the engine.
3. Clean the fuel cap and the area around the fuel cap to
prevent dirt from entering the fuel tank. Remove the
cap from the fuel tank.
4. Fill the fuel tank to within 1 in. (25 mm) below bottom of
filler neck.
5. Replace fuel cap and tighten.
6. Clean up any spilled fuel.
PRE-START
CAUTION: Make sure all hardware is tight, all
safety devices in place and all adjustments made
correctly.
1. Check Safety Interlock System
If this system does not function as described do not operate
until repairs are made.
2. Check Air Cleaner
Check air filter for dirt. Clean as required. Follow Engine
Manual Maintenance Schedule.
3. Check Engine Fuel and Crankcase Oil
Check and add fuel if required. Check that engine crankcase
oil is full. Follow Engine Manual Maintenance Schedule.
4. Check Tire Pressure
5. Check Hydraulic Fluid Level
6. Adjust Seat
Be sure all controls can be reached safely from operator's
position.
STOPPING IN AN EMERGENCY
The unit can be stopped immediately at any time by turning
the ignition key to the Off position.
STARTING AND SHUT OFF
CAUTION: Read entire Owner/Operator Manual,
Clutch Manual, and Engine Manual first. DO NOT
attempt to start engine at this time.
GB - 10