Removing Speed Control Plate; Removing Injection Pump - Kubota WSM 05-E4B Series Workshop Manual

4. ENGINE
7. Remove the stop solenoid mounting bolt (3) with
boost compensator assembly (2).
(1) Stop solenoid
(2) Boost compensator assem-
bly
(3) Stop solenoid mounting bolt
(When reassembling)
NOTE
• Apply a liquid gasket (Three Bond 1217D or
equivalent) to the boost compensator body.
• Install the stop solenoid mounting bolt (3) in boost
compensator assembly (2) and assemble it to the
boost compensator installation position at the same
time.
• Tighten the boost compensator mounting bolt (5).
• Remove the stop solenoid mounting bolt (3).
• Install the stop solenoid (1) and tighten the
mounting bolt (3).

5.17 Removing speed control plate

1. Remove the engine stop solenoid (without R24
model).
2. Remove the speed control plate (1).
4-38
(4) Hose
(5) Boost compensator mount-
ing bolt
5. Disassembling and assembling
(1) Plate
(When reassembling)
• Apply a liquid gasket (Three Bond 1215 or
equivalent) to both sides of the solenoid cover
gasket and control plate gasket.
• Be careful not to drop the governor spring (2) into
the crankcase.

5.18 Removing injection pump

1. Disconnect the start spring (4) on the thrust lever
side (5).
(4) Start spring
(5) Thrust lever
(6) Governor spring
SERVICING
(2) Governor spring
[A] Basic model
[B] BG model
05-E4B SERIES,05-E4BG SERIES
KiSC issued 03, 2023 A