Speed Control Lever And Governor Lever - Kubota WSM OC60-E2 Workshop Manual

OC60-E2, OC95-E2, WSM

(8) Speed Control Lever and Governor Lever

Speed Control Lever and Speed Adjust Lever Shaft
(When reassembling)
Install the O-ring onto the crankcase, and apply oil. Place the
flat washer, friction plate, key and spring in this order as shown
in the figure.
Hook the spring as illustrated.
1) Hooking to the speed control lever (1).
2) Hooking to the crankcase (2).
(1) Speed Control Lever
Governor Lever 1, 3 and Governor Spring (OC60-E2)
(When reassembling)
Clean up the governor lever shaft and the shaft hole. Apply oil
to them.
Install the oil seal onto the crankcase.
Make sure the bearing (2) of the governor lever 1 (1) moves
smoothly.
Put the governor lever into the hole.
Hook the idle spring (3) into position.
Position the stop lever of the speed control lever shaft
behind the governor lever 1 (1). See the figure.
Install the governor lever 3 (4) from outside the
crankcase.
Put the spring pin (5) and see if there is a clearance of 0.1
to 0.3 mm in the axial direction.
Pull the speed control lever toward the stop position
(toward the side cover), and hook the governor spring.
Hook the governor spring to the governor lever 3 (4) first
and then into the second hole from outside in the speed
lever.
(1) Governor Lever 1
(2) Bearing
(3) Idle Spring
S-34
ENGINE
(2) Crankcase
0000009245E
(4) Governor Lever 3
(5) Spring Pin
0000009246E