Kubota WSM 05-E4B Series Workshop Manual page 129

SERVICING
5. Disassembling and assembling
2. Remove the solenoid switch mounting nuts (1) and solenoid switch (5).
3. Remove the end frame cap (17).
4. Remove the brake shoe (16), brake spring (15) and gasket (14).
5. Remove the through bolts (22) and rear end frame (13).
6. Remove the brush from the brush holder while holding the spring up.
7. Remove the brush holder (21).
8. Draw out the yoke (19) from the starter drive housing (2).
9. Draw out the armature (10) with the drive lever (3).
(1) Solenoid switch mounting nut
(2) Starter drive housing
(3) Drive lever
(4) Gasket
(5) Solenoid switch
(6) B terminal nut
05-E4B SERIES,05-E4BG SERIES
(7) C terminal nut
(8) Snap ring
(9) Overrunning clutch
(10) Armature
(11) Brush spring
(12) Connecting lead
(13) Rear end frame
(14) Gasket
(15) Brake spring
(16) Brake shoe
(17) End frame cap
(18) Screw
4. ENGINE
(19) Yoke
(20) Brush
(21) Brush holder
(22) Through bolt
4-47
KiSC issued 03, 2023 A