Table of Contents
Advertisement
Changing the Port Number
Typically, conventional port numbers are used for major protocols, but these port numbers may be changed to
enhance security. As the port numbers must be the same on communicating devices, such as a computer or server,
when the port number is changed, the setting on the machine also needs to be changed.
This section describes how to configure the settings using Remote UI from a computer.
On the operation panel, select [Menu] in the [Home] screen, and then select [Preferences] to configure the settings.
[Port Number Settings](P. 215)
Administrator privileges are required. The machine must be restarted to apply the settings.
1
Log in to Remote UI in System Manager Mode.
2
On the Portal page of Remote UI, click [Settings/Registration].
Remote UI(P. 181)
3
Click [Network Settings]
➠
The [Edit Port Number Settings] screen is displayed.
4
Change the port number of the protocol, and click [OK].
5
Restart the machine.
➠
The settings are applied.
Protocol Settings
●
For the protocol settings and settings of the functions using the protocol, see the following:
LPD/RAW/WSD
Configuring LPD, RAW, or WSD(P. 172)
HTTP
Disabling HTTP Communication(P. 174)
SNMP
Configuring SNMP(P. 61)
Changing the Port Number of the Proxy Server
●
To change the port number of the proxy server, see the following:
Using a Proxy(P. 151)
Changing the Port Number of the Printer Driver (Windows)
●
When the port number of the print protocol (LPD or RAW) is changed on the machine, change the port
number setting on the computer too.
Security
[Port Number Settings]
Restarting the Machine(P. 75)
Configuring a Printer Port (Windows)(P. 104)
150
Starting Remote UI(P. 179)
Portal Page of
[Edit].
95LW-03R
Advertisement
Table of Contents
