Removal/Installation Of Wire Wheel - Husqvarna Rider 13C Workshop Manual

Reparation instructions

Removal/installation of wire wheel

1. Remove the frame plate.
2. Detach the steering wires' rear attachment (1)
.
3. Remove the screw (2) and detach the wire
wheel (5).
4. Remove the bearing's circlip (3) and knock out
the bearing (4).
5. To install the wire wheel, the reverse order is
applied.
30
– English
The screw (2) is to be mounted in the rear
hole on the frame. The bushing (6) is to be
placed between the frame and the cable
pulley.
Ensure that the cables are properly situated
under the steering cable rollers (7) in the
frame tunnel.
Ensure that the steering wheel is in the centre
position when the rear wheels are centred.
Re-set the chain on the steering column's
sprocket or adjust the rear fixture (1) for the
steering cables as needed.
Hold the cables with, for example, a wrench
when mounting so that they do not twist.
After installation, check the wire tension (see
"Checking and adjusting steering wires").