Removing The Cutting Unit - Husqvarna Rider 13C Workshop Manual

Removing the cutting unit

Combi unit
1
• Apply the parking brake.
• Adjust the cutting height to its lowest setting.
• Remove the front cover.
2
Release the two support wheels under the front
cover.
3
Fit the two support wheels on each side of the
lower part of the deck.
WARNING!
Wear protective glasses when
removing the cutting unit. The
spring which tensions up the
belt can go off and cause perso-
nal injury.
50
– English
3
Release the spring for the drive belt's tensioning
wheel. Move the cutting height lever to the lower
position.
4
Place one foot on the front edge of the deck by
the wheel, and lift the front edge of the deck to
simplify releasing the height setting rod. Secure
the rod in the holder.
Reparation instructions