Removal Of Blades With Bearings - Husqvarna Rider 13C Workshop Manual

Removing Blades with Bearings
WARNING!
Use gloves and protective
eyewear when working with the
cutting unit.
Combi 112
You can recognise this unit by the fact that the
collar on the bearing housing is located on the top
of the unit's cover.
1. Remove the cutting unit's upper cover, see
"Belt Replacement: the Combi 94, 103, 112".
2. Loosen the spring (1) that tensions the V-belt
and pull the belt off.
3. Remove the screws holding the pulley (2).
Lock the blade with a wooden block or hold
the belt pulley in place, with an oil filter
wrench, for example. Do not lose the key that
sits between the pulley and the shaft. Remove
the pulley. A puller may be required for this.
4. Loosen the blade bolt and remove the blade
bolt, washer and blade.
5. Loosen the four screws that hold the blade
bearing and remove the entire bearing
assembly from the cutting unit.
54
– English
Belt adjuster spring and belt pulley
Locking the blades
Blade bolt
Screws, blade bearing
Reparation instructions