Removal/Installation Of Wire Wheel - Husqvarna Rider 18 ProFlex Workshop Manual

Reparation instructions

Removal/installation of wire wheel

1
Detach the steering wires' rear attachment (1) .
2
Remove the screw (2) and detach the wire wheel
(3).
3
Remove the bearing's circlip (4) and knock out the
bearing (5).
4
To install the wire wheel, the reverse order is
applied.
After installation, check the wire tension (see
"Checking and adjusting steering wires").
A complete installation kit, including wire pulley,
bushing and bearing, can be purchased for the
Rider 18 ProFlex and Rider 20 ProFlex.
23
English –