Table of Contents
Advertisement
3.1 Introduction - Installation
Read this chapter to install the product with a boundary
wire. A boundary wire is not necessary if you install the
™
product with the EPOS
for the reference station EPOS
the product.
WARNING:
safety chapter before you install the product.
CAUTION:
installation material.
Note:
Refer to www.husqvarna.com for more
information about installation.
3.2 Main components for installation
The installation involves the following components:
•
A robotic lawn mower that mows the lawn
automatically.
•
A charging station, which has 3 functions:
•
To send control signals along the boundary
wire.
•
To send control signals along the guide wire
so that the product can follow the guide wire
to specific remote areas in the garden and
can find its way back to the charging station.
•
To charge the product.
•
A power supply, which is connected to the
charging station and a 100-240V power outlet.
•
Loop wire, which is laid around the work area
and around objects and plants that the product
must not run into. The loop wire is used both as
boundary wire and guide wire.
3.3 To prepare for installation
Read the installation chapter before you start the
installation. Prepare the installation carefully to make the
product operate satisfactorily.
•
Make a blueprint of the work area and include all
obstacles. This makes it easier to examine where
to put the charging station, the boundary wire and
the guide wire.
•
Make a mark on the blueprint where to put the
charging station, the boundary wire and the guide
wire.
12 - Installation with wire
3 Installation with wire
. Read the operator's manual
™
RS1 to install it with
Read and understand the
Use original spare parts and
•
Make a mark on the blueprint where the guide wire
connects to the boundary wire. Refer to
the guide wire on page 18 .
•
Fill in holes in the lawn to make it level.
CAUTION:
the lawn can cause damage to the
product.
®
•
For Automower
310E NERA, make sure that
you have Wi-Fi coverage in the charging station
to download new firmware. Refer to
firmware over the air FOTA (Firmware over the air)
on page 24 . For Automower
or cellular technology is used for FOTA.
®
•
For Automower
310E NERA, make sure that
you have Wi-Fi coverage in the work area if you
use the Automower
To install the Automower
to
page 16 . For Automower
or cellular technology is used for Automower
Connect.
Note:
We recommend you to have Wi-Fi
coverage in the work area. If you have Wi-Fi
coverage, you can control and make settings
for the product remotely with the Automower
Connect app. The product automatically connects
to Wi-Fi when it is in an area that has Wi-Fi
coverage.
•
Cut the grass and trim the edges before you install
the product. Make sure that the grass is maximum
6 cm / 2.5 in.
Note:
The first weeks after installation the sound level
when the product cuts the grass can be higher than
usual. The sound level decreases after some time.
3.4 Before the installation of the wires
You can select to attach the wires with stakes or bury
them. You can use the 2 procedures for the same work
area.
CAUTION:
in the work area, bury the boundary wire
and the guide wire to prevent them from
damage.
3.4.1 To examine where to put the charging
station
•
Keep a minimum 3 m / 10 ft. of free space in front
of the charging station. Refer to
to put the guide wire on page 15 .
To install
Holes with water in
Download
®
410XE NERA Wi-Fi
®
Connect app remotely. Refer
®
Connect app on
®
410XE NERA Wi-Fi
If you use a dethatcher
To examine where
2369 - 001 - 05.02.2024
®
®
Advertisement
Table of Contents
