Nameplates For Hazardous Area Installations - Siemens 7ML5202 Operating Instructions Manual

• Under certain extreme circumstances, the non-metallic parts incorporated in the enclosure
of this equipment may generate an ignition-capable level of electrostatic charge.
Therefore the equipment shall not be installed in a location where the external conditions
are conducive to the build-up of electrostatic charge on such surfaces.
• In addition, the equipment shall only be cleaned with a damp cloth. This is particularly
important if the equipment is installed in a zone 0 location.
4.3

Nameplates for hazardous area installations

Note
Device-specific approvals
Always refer to nameplates on the device for device-specific approvals.
ATEX and UKEX certificates on nameplate
The ATEX and UKEX certificates listed on the nameplate can be downloaded from the LU180
product page on our website http:wwww.siemens.com/SITRANSLU180.
Go to Support > Approvals > Certificates.
The IECEX certificate listed on the nameplate can be viewed on the IECEx website:
1. Go to http://iecex.iec.ch/
2. Click on Certified Equipment
3. Enter the certificate number IECEx 15.0118X
SITRANS LU180
Operating Instructions, 09/2021, A5E37100674-AB
4.3 Nameplates for hazardous area installations
Connecting
17