Changing The Setpoint Dhw; Password - Lochinvar EFW 85 Installation, Commissioning, User And Maintenance Instructions

Changing the Setpoint DHW.

This can be done directly via the Status overview (as shown below) or via the MENU.
You can adjust the DHW setpoint directly on the bottom of the Status overview.
24.7.1 S A
ET CTUAL SETPOINT
You can adjust the DHW setpoint directly on the bottom of the Status overview.
Press UP/DOWN ↑↓ to select the mode, then press CONFIRM
tual/DHW setpoint becomes directly settable. Use UP ↑ or DOWN ↓ to increase/decrease the setpoint.
Press CONFIRM or RIGHT → to confirm your alteration or press ESC
A setpoint is only visible on the display when no error or alert is active. In case of an active error or alert, the bot-
tom right part of the display is used to display the error or alert text.
24.7.2 C
HANGING THE
Only applicable if this function is available.
Press the UP or DOWN button to select the mode:
DHW Store Setpoint
60.0 °C is the minimum set point according to UK regulation L8, 65.0°C for healthcare settings according to HTM
regulations.
Use the left/right buttons to move the
DHW Store Setpoint
Use UP/DOWN buttons to increase/decrease the setpoint.
Press the ENTER or RIGHT button to confirm your alteration or press the BACK or LEFT button to cancel.
A setpoint is only visible on the main screen when no error or alert is active. In case of an active error or alert,
the bottom right part of the PB screen is used to display the error or alert.

Password

Password
  0
Menus protected by a password are only accessible by the installer.
Passwords are always customer specific and (for safety reasons) will be provided to the installer only!
The following menu items require a password:
Menu item
Startup Settings
Boiler Parameters
Module Cascade Settings
Boiler Cascade Settings
/DHW
SETPOINT DIRECTLY VIA THE
DHW
SETPOINT DIRECTLY
60.0 °C
sign to the front of the temperature digits.
65.0 °C
* * *
Location inside menu
Settings/General Settings/Other Settings/Startup Settings
Settings/Boiler Settings/Boiler Parameters
Settings/Boiler Settings/Module Cascade Settings
Settings/Boiler Settings/Boiler Cascade Settings
S
TATUS OVERVIEW
or RIGHT → to confirm the mode and the Ac-
or LEFT ← to cancel.
.