Table of Contents
Advertisement
Display configuration.
The Status overview has the three different sections that show specific information:
DHW Control
An example of the Status overview and the different sections
Header
-
Left: For cascade systems the cascade icon is shown, with the cascade manager indication (M) or the de-
pendent number.
Center: Shows the CH and/or DHW disabled icons when CH and/or DHW is disabled
-
-
Right: Shows the time (only if the real-time clock is available).
Icon
Description
Cascade icon
CH Disabled
DHW Disabled
Middle section
Left: Shows user-configured information (by default only the outside temperature):
-
Line
Info
Top
Burner state (when enabled)
Middle
Configured/selected temperature (one of the following):
Bottom
CH water pressure (when enabled)
Center: The house icon is always displayed.
-
-
Right side: Shows several status icons:
Icon
Description
CH demand
DHW demand
Emergency mode is active (for cascade systems only)
Burner is on (and flame is detected)
Frost protection is active.
Anti-legionella program is active.
Error is set in the Main Control (see footer for error description)
Footer
Shows Error/Warning messages when an Error or Warning is set in the Main Control, otherwise a quick menu is
displayed where the user can quickly edit setpoints and enable/disable CH or DHW.
Quick Menu / Parameter
Calculated Setpoint
DHW Control
DHW (Store) Setpoint
Note: Cascade dependents will only have the 'Calculated Setpoint' available.
74
Enabled
▪
Outside temperature
▪
Demand based (Flow or DHW temperature based on active demand)
▪
Flow temperature
▪
DHW temperature
▪
System temperature (module cascade flow/supply temperature)
▪
Cascade temperature (boiler cascade flow/supply temperature)
Description
Show the calculated setpoint (when available)
Enable/disable Domestic Hot Water
Edit the DHW (Store) setpoint (when available).
Header
Middle section
Footer
E93.1804.014
Value /
User
Unit
level
0: User
0: User
0: User
Advertisement
Table of Contents
