15 ELECTRICAL SYSTEM
15.9
15.10
122
E00359-10
Checking the headlight setting
400726-10
Adjusting the headlight range
V00369-10
–
3
Pull out headlight bulb
–
Insert the new headlight bulb.
Headlight (HS1 / socket PX43t) (
–
Insert the protection cap with the bulb socket into the reflector
and turn it clockwise all the way.
Info
Ensure that O-ring
–
Insert the bulb socket of the position light into the reflector.
Finishing work
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
–
Position the vehicle upright on a horizontal surface in front of
a light wall and make a marking at the height of the center of
the low beam headlight.
–
Make another mark at a distance
Guideline
B
Distance
–
Position the vehicle vertically at a distance
wall.
Guideline
A
Distance
–
The rider now sits down on the motorcycle.
–
Switch on the low beam.
–
Check the headlight setting.
The boundary between light and dark must be exactly on the
lower mark for a motorcycle with rider.
»
If the boundary between light and dark does not meet
specifications:
–
Adjust the headlight range. (
Preparatory work
–
Check the headlight setting. (
Main work
–
1
Loosen screw
.
–
Adjust the headlight range by pivoting the headlight.
Guideline
The boundary between light and dark must be exactly on the
lower mark for a motorcycle with rider (instructions on how
to apply the mark: Checking the headlight setting).
.
p. 154)
4
is seated properly.
p. 121)
p. 122)
B
under the first marking.
5 cm (2 in)
A
away from the
5 m (16 ft)
p. 122)
p. 122)