Transporting; Transporting The Chain Saw; Storing; Storing The Chain Saw - Stihl MS 500i Instruction Manual

English
putting it down. To reduce the risk of injuries from the sharp
cutters on the chain, always cover the guide bar with the
chain scabbard before transporting or storing the saw.
To prepare the saw for transportation or storage:
► Shut off the engine, @ 15.
► Release the chain brake and loosen the chain, @ 12.2.
► Re-engage the chain brake.
► Slide a chain scabbard over the guide bar so that it covers
the entire guide bar.
► Before using the saw, remember to re-tension the chain.
NOTICE
The chain contracts as it cools down. Failing to loosen the
chain after finishing work can damage the drive shaft and
bearings.

18 Transporting

18.1 Transporting the Chain Saw

When transporting the chain saw:
► Slide a chain scabbard over the guide bar so that it covers
the entire guide bar.
46
► When transporting the saw by hand, hold it by the front
handle with the guide bar pointing backwards, opposite
the direction in which you are walking. Place the muffler
away from the body.
► When transporting the saw in a vehicle, cover the guide
bar with a chain scabbard. Secure and position the chain
saw to prevent turnover, fuel spillage, impact and
damage.
Your saw comes standard with a chain scabbard that
matches the cutting attachment. If you use guide bars of
different lengths on the saw, the length of the chain
scabbard must be matched to the guide bar to reduce the
risk of injury. It should cover the full length of the guide bar.

19 Storing

19.1 Storing the Chain Saw

WARNING
Store the chain saw indoors in a dry, secure place that
cannot be accessed by children or other unauthorized users,
@ 5.4. Improper storage can result in unauthorized use and
damage to the chain saw, @ 5.4.
When storing the saw short-term:
► Wait for the engine to cool down.
► Keep the machine with a full tank of fuel in a dry place,
well away from sources of ignition, until you need it again.
When storing the saw for three months or longer:
► Drain and clean the fuel tank in a well ventilated area.
Dispose of fuel properly in accordance with local
environmental requirements.
► Run the engine until it shuts off.
► Remove the chain and guide bar.
► Clean and spray the guide bar with a resin solvent, such
as STIHL Resin Remover and Lubricant.
► Clean the saw, @ 20.1.
► Clean the air filter, @ 20.3.
18 Transporting
0458-809-8621-A