Table of Contents
Advertisement
12 After Finishing Work
11.9.9
Felling a small diameter leaner
A leaner is felled with a felling cut and holding
strap. This felling cut must be performed if the
tree diameter is less than the guide bar's length.
► Shout a warning.
► Plunge the guide bar into the felling cut until it
is visible at the other side of the trunk,
11.9.5.
► Enlarge felling cut in direction of hinge.
► Enlarge felling cut in direction of holding strap.
► Shout a warning.
► With arms outstretched, cut through the hold‐
ing strap from outside at a downward angle.
The tree falls.
11.9.10
Felling a large diameter leaner
A leaner is felled with a felling cut and holding
strap. This felling cut must be performed if the
tree diameter is greater than the guide bar's
length.
► Shout a warning.
1.
2.
3.
► Apply the spiked bumper behind the holding
strap at the same height as the felling cut and
use it as a pivot.
► Hold the saw horizontally and swing it into the
felling cut as far as possible.
0458-784-0121-C
► Enlarge felling cut in direction of hinge.
► Enlarge felling cut in direction of holding strap.
► Move to the other side of the tree.
► Apply the spiked bumper behind the hinge at
► Hold the saw horizontally and swing it into the
1.
2.
► Enlarge felling cut in direction of hinge.
► Enlarge felling cut in direction of holding strap.
► Shout a warning.
► With arms outstretched, cut through the hold‐
12 After Finishing Work
12.1
► Shut off the engine and engage the chain
► Allow chainsaw to cool down.
► If the saw is wet: Allow the saw to dry.
► Clean the saw.
► Clean the bar and chain.
► Loosen nuts on the chain sprocket cover.
► Turn the tensioning screw two full turns coun‐
► Tighten down nuts on the chain sprocket
► Fit the scabbard so that it completely covers
13 Transporting
13.1
► Shut off the engine and engage the chain
5.
6.
4.
► Fit the chain scabbard so that it completely
Carrying the chainsaw
► Carry the chainsaw by holding the front handle
the same height as the felling cut and use it as
a pivot.
felling cut as far as possible.
ing strap from outside at a downward angle.
The tree falls.
After Finishing Work
brake.
terclockwise.
The chain is now slack.
cover.
the guide bar.
Transporting the Chainsaw
brake.
covers the guide bar.
in your right hand with the guide bar pointing
to the rear.
English
23
Advertisement
Table of Contents
