After Finishing Work; Transporting - Stihl MSA 300.0 Instruction Manual

English
► Plunge the guide bar into the felling cut until it
is visible at the other side of the trunk,
13.6.5.
► Enlarge felling cut in direction of hinge.
► Enlarge felling cut in direction of holding strap.
► Shout a warning.
► With arms outstretched, cut through the hold‐
ing strap from outside at a downward angle.
The tree falls.
13.6.10 Felling a large diameter leaner
A leaner is felled with a felling cut and holding
strap. This felling cut must be performed if the
tree diameter is greater than the guide bar's
length.
► Shout a warning.
1.
2. 3.
► Apply the spiked bumper behind the holding
strap at the same height as the felling cut and
use it as a pivot.
► Hold the saw horizontally and swing it into the
felling cut as far as possible.
► Enlarge felling cut in direction of hinge.
► Enlarge felling cut in direction of holding strap.
► Move to the other side of the tree.
56
► Apply the spiked bumper behind the hinge at
1.
2.
► Hold the saw horizontally and swing it into the
► Enlarge felling cut in direction of hinge.
► Enlarge felling cut in direction of holding strap.
► Shout a warning.
► With arms outstretched, cut through the hold‐

14 After Finishing Work

14.1
► Switch off chainsaw, engage the chain brake
► If the chainsaw is wet: Allow the chainsaw to
► If the battery is moist or wet: Allow the battery
► Clean the chainsaw.
► Clean the guide bar and saw chain.
► Loosen the nuts on the chain sprocket cover.
► Back off the tensioning screw 2 turns counter‐
► Tighten nuts.
► Push the chain scabbard over the guide bar so
► Clean the battery.
5.
6.
4.

15 Transporting

15.1
► switch off chain saw, engage chain brake and
► Fit the chain scabbard so that it completely
Carrying the chainsaw
► Carry the chainsaw by holding the front handle
the same height as the felling cut and use it as
a pivot.
felling cut as far as possible.
ing strap from outside at a downward angle.
The tree falls.
After Finishing Work
and remove the battery.
dry.
to dry, 21.6.
clockwise.
The saw chain is now slack.
that it completely covers the guide bar.
Transporting the Chainsaw
remove battery
covers the guide bar.
in your right hand with the guide bar pointing
to the rear.
14 After Finishing Work
0458-009-9602-A