Table of Contents
Advertisement
STEP 15
• Insert two GUIDE RODS (33) into the WEIGHT
STACK BASE (3) as shown on FIGURE 15.
(NOTE: Lubricate GUIDE RODS (33) with
silicon or teflon spray available at most hard-
ware stores.)
• Slide two WEIGHT STACK SPACERS (34), two
3/4" WASHERS (53), and two WEIGHT STACK
CUSHIONS (88) - IN THAT ORDER - down
over the GUIDE RODS (33).
• Using EXTREME CARE slide all fifteen
WEIGHT PLATES (74) down over the GUIDE
RODS (33) on to the WEIGHT STACK CUSH-
IONS (88). Make sure that the keyholes of the
WEIGHT PLATES (74) are all facing the right
way.
•
Slide the head plate assembly down over the
GUIDE RODS (33) onto the weight stack.
• Insert two CAP PLUGS (89) into the top ends of the
GUIDE RODS (33).
• Attach the WEIGHT STACK LABELS (94) to the
weight stack. (NOTE: LABELS should start
with the Headplate) Also insert the WEIGHT
STACK PIN (57) over the WEIGHT PLATE
SHAFT (80) as shown.
44 1/2 X 4"
52
16
33
FIGURE 15
7
51
Route LAT
CABLE over bolts
51
39 3/8 X 3"
11
49
89
33
80
57
94
88
53
34
STEP 16
• Swing the GUIDE RODS (33) under the TOP
48
• Loosely assemble the TOP BOOM (7) to the
• Loosely assemble the TOP BOOM (7) to the
92
FIGURE 16
14
81
74
3
BOOM (7) as shown on FIGURE 16.
REAR UPRIGHT (16) using two 1/2 X 4"
BOLTS (44), two 1/2" WASHERS (52), and
one 1/2" LOCKNUT (49).
FRONT UPRIGHT (11) using two 3/8 X 3"
BOLTS (39), four 3/8" WASHERS (51), and
two 3/8" LOCKNUTS (48). Make sure LAT
CABLE (92) is routed OVER top of bolts.
Advertisement
Table of Contents
