Operation; Controls And Indications - Extron electronics DTP T USW 333 User Manual

Operation

Controls and Indications

AUTO
SWITCH
CONFIG
A A D D
Figure 8.
Auto Switch mode indicator
A
Input selection controls and indicators
B
C
Auto-input switching mode controls
The switcher supports auto‑input switching mode. When auto‑input switching mode is
enabled, the switcher continuously monitors all inputs and automatically switches to the
highest‑numbered input with video sync pulses present. If video is absent from all inputs,
input 1 is selected.
D
E
F
C C
1 2
MODE
NORMAL
E E
B B
Power Indicators
Auto Switch LED — When lit, indicates that the switcher is in auto‑input switching
mode. When unlit, the switch is in normal (manual) mode (see
mode on page 11).
Input 1 through 3 buttons — Each Input button selects the associated input for
output (see Switching inputs
The Input buttons are also used to toggle auto‑input switching mode on and off (see
"Auto‑input switching mode controls," below).
Input 1 through 3 LEDs — The input LEDs identify the selected input.
Mode button — The Mode button is used with the Normal button or the Auto button
to select the switching mode (see
This button is a secondary function of the Input 1 button.
Normal button — The Normal button is used with the Mode button to select normal
mode (see Selecting the switch mode
This button is a secondary function of the Input 2 button.
When you change from auto‑input switching to normal (manual) mode, the last input
selected in auto‑input switching mode remains selected until you manually select a
different input.
Auto(switch) button — The Auto button is used with the Mode button to select auto‑
input switching mode (see
This button is a secondary function of the Input 3 button.
3
SIGNAL
AUTO
F F
on the next page).
Selecting the switch mode
on page 11).
Selecting the switch mode
DTP T USW 333 • Installation and Operation
STATUS
1 2 3
HDCP
DTP T USW 333
G G
Selecting the switch
on page 11).
on page 11).
9