Table of Contents
Advertisement
3.
Locate and lift off jumpers JMP1 and JMP2 (see figure 12).
Figure 12.
Jumper Locations
4.
Reinstall the switcher cover, securing it in place with the screws removed in step 2.
5.
Reinstall the switcher in the rack or other installation option (see
Switcher
on page 18).
6.
If you are using shielded cable, disconnect the cable shield from the connector at
either end of the cable.
7.
See the manual for the applicable receiver, DTP DVI 330 Rx or DTP HDMI 330 Rx,
available at www.extron.com, and remove the ground jumpers in the receiver.
8.
Obtain a second 12 V power supply (one supply is provided with the switching
transmitter and normally powers both units), and locally power both units (see
supply wiring
on page 7).
Mounting the
DTP T USW 333 • Reference Information
JMP2
JMP1
Power
20
Advertisement
Table of Contents
