Parameter Values - Dc 1550/Da321G - Dürkopp Adler 52 i-75 Series Operating Instructions Manual

Setting of positioning motor
Operating Instructions 52Xi, 52Xi-75 - 03.0 - 09/2023
8.1.1

Parameter values - DC 1550/DA321G

The description of parameter entering is in the publication attached
by the motor manufacturer "Efka Operating Instructions" or on the
website www.efka.net.
For machines with gear rate 1:1 and with the toothed belt
Parame- Original
ter value
290* 0
270 6
111 1000
170 -
190 170
192 160
272 1063
For machines with another gear rate and wit another belt
Parame- Original
ter value
290* 0
111 1000
170 -
190 170
192 160
* Parameter necessary to be entered as the first.
Important
To set parameters higher than 200 it is necessary to enter the
control with a programmer's authorization (through code 3112).
The access is then enabled to parameters lower than 200.
New
Parameter description
value
19 Machine class
0 Choice of sensor type
- Sewing speed maximum
- Reference position
120 Switch on angle of thread trimmer
140 Delay angle of tensioner release
1000 Gear rate
New
Parameter description
value
19 Machine class
- Sewing speed maximum
- Reference position
120 Switch on angle of thread trimmer
140 Delay angle of tensioner release
97