Frymaster MJ45 Installation, Operation And Maintenance Manual page 19

Performance Pro Series Atmospheric gas fryers (J1C Series excluded) have received the CE mark
for the countries and gas categories indicated in Table 3 below.
The size of the gas line used for installation is very important. If the line is too small, the gas
pressure at the burner manifold will be low. This may cause slow recovery and delayed ignition.
The incoming gas supply line should be a minimum of 1½" (38 mm) in diameter. Refer to the Table
4 below for the minimum sizes of connection piping.
CE regulations require a combustion air supply of 2m
affixed to door for kW rating.)
SOUTH AFRICA REQUIREMENT (LPG FRYERS ONLY)
This appliance requires an operating pressure of 2,8 kPa at the appliance. A suitable LPG regulator
that complies with the requirements of SANS 1237 must be installed.
1. Connect the quick-disconnect hose to the fryer quick-disconnect fitting under the front of the
fryer and to the building gas line. The gas inlet connection will be up to 1.5" NPT (38.1mm),
depending on the number of fryers in the battery. The gas connection point will be about 13"
Table 3: CE Approved Gas Categories
Country Category
I2E+(S)
BE
I3P
I2 ELL
DE
13P
DK-GR-IT
I2 H
FR
II2Esi3P
LU
I2E
ES
II2H3P
NL
II2L3P
IE-PT-GB
II2H3P
Table 4: Gas Connection Pipe Sizes
(Minimum incoming pipe size should be 1-1/2" (38 mm))
Gas Single Unit
Natural 3/4" (19 mm)
Propane 1/2" (13 mm)
Manufactured 1" (25 mm)
* For distances of more than 20 feet (6 meters)
and/or more than four fittings or elbows, increase
the connection by one pipe size.
CE Standard
Pressure
Gas (mbar)
G20/G25 20/25
G31 37
G20/G25 20
G31 50
G20 20
G20/G25 20/25
G31 37 ET 50
G20/G25 20/25
G20 20
G31 37 ET 50
G25 25
G31 50
G20 20
G31 37
2 - 3 Units 4 Units*
1" (25 mm) 1-1/4" (33 mm)
3/4" (19 mm) 1" (25 mm)
1-1/4" (33 mm) 1-1/2" (38 mm)
3
/h per kW per fryer. (See rating plate
2-8