Frymaster MJ45 Installation, Operation And Maintenance Manual page 16

57.82 41.00
47.67
(1041)
(1469)
(1211)
SINGLE
46.00
49.12
(1168)
(1248)
FILTER
12.83
(326)
8.40
(213)
CORD SET
2.3 Caster/Leg Installation
DO NOT install this appliance without legs or casters.
Depending upon the specific configuration ordered, the fryer might have been shipped without
installed casters or legs. If casters or legs are installed, you may skip this section and proceed to
Section 2.4, Pre-Connection Preparations. DO NOT INSTALL THIS APPLIANCE WITHOUT
CASTERS OR LEGS.
If your fryer requires the installation of casters/legs, install them in accordance with the
instructions included in your accessory package.
On an appliance with casters; the installation shall be made with a connector that complies with the
Standard for Moveable Gas Appliances, ANSI Z21.69 • CSA 6.16, and a quick disconnect device
that complies with the Standard for Quick-Disconnect Devices for Use With Gas Fuel, ANSI Z21.41
• CSA 6.9.
2.4 Pre-Connection Preparations
Do not connect this appliance to the gas supply before completing each step in this
section.
After the fryer has been positioned under the fry station exhaust hood, ensure the following has been
accomplished:
1. Adequate means must be provided to limit the movement of fryers without depending upon the
gas line connections and the quick-disconnect device or its associated piping to limit the
CORD SET
HEAT LAMP
6.00
CORD SET
(152)
34.55
(878)
31.55
(801)
3.00
36.50
(76)
(927)
35.75
(908)
6.10
(155)
The 35 in a single cabinet is available
35
with an optional lower rear gas
connection, which accommodates
installations closer to the wall. The
gas assembly, 108‐5651, is available
with an NPT‐to‐BSP adapter,
INCHES
813‐0540.
(MM)
FOOD WARMER
46.86
(OPTIONAL)
(1190)
31.24
(793)
15.62
(397)
50.64
(1286)
DANGER
DANGER
2-5
23.63
(600)
2.50
(64)
HEAT LAMP
5.50' CORD SET
120V
Gas
Connection
Gas
Connection