Maintenance; Recommended Maintenance Schedule(S) - Toro 38494 Operator's Manual

Commercial walk-behind mower
Table of Contents

Advertisement

Maintenance

Note: Determine the left and right sides of the machine from the normal operating position.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 8 hours
Before each use or daily
Every 25 hours
Every 50 hours
Every 100 hours
Every 200 hours
Every 400 hours
Before storage
Important: Refer to your Engine Operator's Manual for additional maintenance procedures.
If you leave the key in the ignition switch, someone could accidently start the engine and seriously
injure you or other bystanders.
Remove the key from the ignition and disconnect the spark plug wires from the spark plugs before you
do any maintenance. Set the wires aside so that they do not accidentally contact the spark plugs.
Maintenance Procedure
• Change the engine oil.
• Check the hydraulic fluid level.
• Change the hydraulic filter.
• Check the safety interlock system.
• Grease the front caster pivot bearing.
• Check the engine oil level.
• Clean the air intake screen.
• Check the brakes.
• Inspect the blades.
• Clean the mower deck.
• Clean foam air cleaner element.
• Check the battery electrolyte level.
• Check the hydraulic fluid level.
• Grease the side bearings.
• Grease the PTO belt idler.
• Grease the mower deck belt idler.
• Check the paper air cleaner element.
• Check the tire pressure
• Check the mower belt.
• Check the PTO drive belt.
• Check the pump drive belt.
• Check the spark plugs.
• Check the electric clutch.
• Check the hydraulic lines.
• Replace the paper air cleaner element.
• Change the oil filter.
• Replace the fuel filter.
• Change the hydraulic filter.
• Grease the front wheel bearings (more often in dirty or dusty conditions).
• Paint chipped surfaces.
• Perform all maintenance procedures listed above before storage.
22

Advertisement

Table of Contents
loading

Table of Contents