Toro 38494 Operator's Manual page 39

1. Cam
2. Nut and bolt
3. Wing nut
9. After the cam is adjusted, the lever switch needs to
be checked.
10. Check the gap between the control lever and switch
as shown in Figure 47. The gap needs to be an 1/8
inch (3mm).
11. If needed, loosen the screws holding the switch and
adjust the switch.
12. Tighten the screws and install the cover under the
control panel.
Figure 46
4. Turnbuckle
5. Switch screws
1. Right side motion control
lever pivot shown under
controls
2. Right side motion control
lever
Adjusting the Neutral Postion for the
Motion Control Levers
Important: Ensure the tracking of the mower is
correct after adjusting the motion control levers.
After adjusting the tracking, the motion control
levers may not align the exactly front to back
(Figure 48).
If the motion control levers do not align front to back,
or the right side control lever does not move easily into
the neutral lock position, adjustment is required. Adjust
each lever and control rod separately.
Note: Adjust the horizontal alignment before the front
to back alignment.
1. After the horizontal alignment is finished, check the
front to back alignment (Figure 48).
39
Figure 47
3. 1/8 inch (3mm) gap
needed between switch
and control lever
4. Switch