Table of Contents
Advertisement
Wall Mount On / Off Switch and Battery Holder Installation
Required for all installations
IMPORTANT INSTALLATION NOTE:
The battery holder must be placed inside the supplied (low voltage) junction type wall box and installed into the wall only.
DO NOT INSTALL WITHIN THE CONFINES OF THE FIREPLACE
SWITCH MUST BE ACCESSIBLE
Battery Holder Installation
1. Install the low voltage junction box to the framing, at desired location within 11-1/2 ft. from fireplace.
2. Feed the 6 pin connector wiring harness through the opening at back of junction box. The wiring harness is located on the right
hand side and must be installed prior to finishing.
3. Connect the 6 pin connector to the back of the Battery Holder.
4. Install the Battery Holder in the Low Voltage Junction box.
5. Insert the 4 AA type batteries (optional) in the battery compartment with the correct polarity.
Note: Batteries are only required for non power vent model. Batteries are only a secondary power source if 120 VAC power is
lost. Batteries should only be placed inside the compartment if there is no 120 VAC supplied to the appliance or 120VAC power
has been lost within home.
6. Place the slider into the cover plate.
7. Put the Battery Holder switch in the "OFF" position, to allow correct lineup for slider switch.
1
8. Make sure the Battery Holder and cover plate words "ON" and "UP" are on the same side.
9. Align the slider with the switch on the Battery Holder and couple the switch into the slider.
10. Align the screw holes.
11. Using the two (2) screws provided secure the cover plate to the Battery Holder.
12. For coding instructions, see full details in this manual.
Proflame Battery Holder
2
ON
REMOTE
OFF
6
3
1
2
Item
Part No.
1
N/A
2
911-335
911-343
3
911-337/P
4
N/A
5
910-369
6
911-181
4
5
Description
Slider Switch (included with
wall plate)
Wall Plate - White
Wall Plate - Black
Battery Holder
J-Box
Low Voltage Junction Box
Battery Holder Wire Harness
installation
City Series CV50E |
45
Advertisement
Table of Contents
