Supermicro X11QPL User Manual page 13

Quick Reference Table
Jumper Description
J1 PWR Fail Trigger Thermal Throttle
JBR1 Top (BOOT) Block Swap
JBJ2 ASD debug enabled jumper
JBT1 CMOS Clear
JP1 CPLD flash header
JPB1 BMC Enabled/Disabled
JPG1 VGA Enabled
JPME1 ME Recovery
JPME2 Manufacture (ME) Mode Select
JWD1 Watch Dog Enabled
JA1/JB1/JC1/JD1 VRM_12C header
Connector Description
COM Backplane COM port
FAN1-6 System/CPU cooling fan headers (FAN1- FAN6)
IPMI_LAN Dedicated IPMI_LAN port
I-SATA0-3 SATA 3.0 ports 0-3 supported by the Intel C621 chipset
JBAT1 Onboard CMOS battery
JF1 Front control panel header
Chassis Intrusion header (Note: please connect a cable from JL1 to the chassis to receive alerts
JL1
via IPMI when the chassis is forced open.)
JMD1 M.2 PCI-E 3.0 x4 SATA4 Connector (M-Key 22110)
JMD2 M.2 PCI-E 3.0 x4 S-SATA2 Connector (M-Key 22110)
JNVME_P1/JNVME_P2/
P1_NVME0/P2_NVME0/P3_NVME0/P4_NVME0
JNVME_P3/JNVME_P4
JPWR1/JPWR2 12V 8-pin power connectors for use of HDD BPN (BPN-NVME3-218L-S2)
JSMB_NVME1 NVME_I2C header
JTPM1 Trusted Platform Module/Port 80 connector
JUSB1 Type A USB 3.0 header
JUSB2 Universal Serial Bus (USB) header with two USB 3.0 connections
LAN1 1GbE port on the front panel
PSU1/PSU2 Power Supply Unit (PSU) 1/ Power Supply Unit 2 for system use
UID (JUIDB1) Unit Identifier (UID) switch
USB 3.0 Two Type A USB 3.0 ports on the front panel.
VGA VGA port
VROC (JRK1) Intel VROC RAID key header for NVMe SSD
Default Setting
Pins 1-2 (Disabled)
Pins 1-2 (Disabled)
Pins 1-2 (Disabled)
Open (Normal)
Pins 1-2 (Enabled)
Pins 1-2 (Enabled)
Pins 1-2 (Normal)
Pins 1-2 (Reset)
13
Chapter 1: Introduction