Supermicro X11QPL User Manual page 100

Super X11QPL User's Manual
SATA Port 0 - SATA Port 3/M.2 SATA Port 1
Hot Plug
Select Enable to support Hot-plugging for the device installed on a selected SATA port
which will allow the user to replace the device installed in the slot without shutting down
the system. The options are Enable and Disable.
Spin Up Device
When this feature is set to Enable, the SATA device installed on the SATA port specified by
the user will start a COMRESET initialization when an edge is detected from 0 to 1. The
options are Enable and Disable.
SATA Device Type
Use this feature to specify if the device installed on the SATA port specified by the user
should be connected to a Solid State drive or a Hard Disk Drive. The options are Hard
Disk Drive and Solid State Drive.
sSATA Configuration

When this submenu is selected, the AMI BIOS automatically detects the presence of the
sSATA devices that are supported by the sSATA controller and displays the following items:
sSATA Controller
This feature enables or disables the onboard sSATA controller supported by Intel PCH. The
options are Enable and Disable.
Configure sSATA as (Available when sSATA Controller is set to Enable)
Select AHCI to configure an sSATA drive specified by the user as an AHCI drive. Select RAID
to configure an sSATA drive specified by the user as a RAID drive. The options are AHCI
and RAID.
SATA HDD Unlock (Available when sSATA Controller is set to Enable)
Select Enable to unlock sSATA HDD password in the OS. The options are Enable and Disable.
SATA/sSATA RAID Boot Select (Available when Configure sSATA as is set to RAID)
This feature allows the user to decide which controller should be used to boot the system.
The options are None, SATA Controller, sSATA Controller, and Both.
Aggressive Link Power Management
When this feature is set to Enable, the sSATA AHCI controller manages the power use of the
sSATA link. The controller will put the link in a low power mode during an extended period of
I/O inactivity, and will return the link to an active state when I/O activity resumes. The options
are Disable and Enable.
100