Stamina Avari Fitness A550-043 Owner's Manual page 8

ASSEMBLY INSTRUCTIONS
NOTE: 1. Refer to the illustration below. The EXTENSION WIRE(80) is connected to the Connection
Wire of the METER(22), and there is a strap attached at the lower end of the EXTENSION
WIRE(80).
2.
Be careful not to damage the sensor wires when processing the following assembly steps.
STEP 4:
Install two AA batteries into the METER(22), the batteries are not included. See page 11 for
detailed battery installation instructions. Remove the GROMMET PLUG(81) from the HANDLEBAR(72).
Run the strap and the EXTENSION WIRE(80) through the HANDLEBAR(72) and slide the METER(22)
onto the plate on the HANDLEBAR(72). Clip the GROMMET PLUG(81) onto Connection Wire of
the METER(22). Push the excess wires into the HANDLEBAR(72) and secure with the GROMMET
PLUG(81).
STEP 5:
Run the strap and the EXTENSION WIRE(80) through the HANDLEBAR POST(71). Insert
the HANDLEBAR(72) into the HANDLEBAR POST(71) and secure with HEX BOLTS(M6x1x33mm)
(75), ARC WASHERS(M6)(76), and NYLOCK NUTS(M6x1)(49). The HEX BOLTS(M6x1x33mm)(75) fit
inside the hex-shaped holes in the HANDLEBAR POST(71).
STEP 6:
Run the strap and the EXTENSION WIRE(80) through the UPRIGHT(68). Insert the
HANDLEBAR POST(71) into the UPRIGHT(68), and lock it in one of the adjustment holes with the
ADJUSTMENT KNOB(69). Remove the strap from the end of the EXTENSION WIRE(80).
NOTE: There are three adjustment holes on the HANDLEBAR POST(71) for adjusting the height of the
HANDLEBAR(72).
Hex-shaped
Adjustment
hole
8
hole
Remove the strap
after the assembly.