Gas - Miele PDR 514 Operating And Installation Instructions

Installation
The use of a gas socket is not permitted at the specified heater rating as the flow rate is
too low.
The gas heating is configured at the factory in line with the gas specifications on the
sticker on the rear of the machine.
If the gas type is changed, a conversion kit must be requested from Miele Service (please
specify the machine type, serial number, gas type, gas group, gas connection pressure,
and country of installation). Follow the installation instructions. This conversion may only
be carried out by an authorized specialist.

Gas

Take these safety precautions if you smell gas
- Extinguish all flames immediately.
- Close the on-site gas shut-off device, the gas shut-off device on the gas meter or the
main gas shut-off device immediately.
- Open all windows and doors immediately.
- Do not light any naked flames (e.g., matches or lighters).
- Do not smoke.
- If there is the smell of gas in a room, never enter the room with an open flame.
- Do not carry out any actions that will create electrical sparks (such as pulling out electri-
cal plugs or pressing electrical switches or bells).
- If you cannot find the cause of the gas smell and all gas valves have been shut off,
please call the gas supply company immediately.
If other persons are being shown how to operate the machine, they must be given and/
or made aware of these important safety precautions.
During installation, the technical regulations for gas installations as well as national and
regional building regulations, fire regulations, and specifications from the relevant gas
supply companies must be adhered to.
When planning a gas-heated system, contact the relevant gas supply company and a
building regulations inspector.
1. What needs to be observed before commissioning
Please specify the gas family, gas group, and connection pressure.
Installation site
Gas-heated tumble dryers must not be operated in a room where cleaning machines oper-
ate with solvents containing perchloroethylene or CFCs. During combustion, any vapors
that are emitted will break down into hydrochloric acid, leading to consequential damage
affecting laundry and the machine. Air exchange must not take place if machines are set
up in separate rooms.
Rooms with fuel-burning installations must be adequately aerated and ventilated. Any gas-
heated machine must be considered to be a fuel-burning installation (regardless of its gas
flow rate).
40