Mounting - Smeg Universale Aesthetic SI4742D Manual

Appliance overall dimensions (mm)
MODELS (cm)
60
Standard and flush mounting (mm)
A B
min 150 min 460 min 750 20 - 60
L X
600-750 560 478÷479
Flush mounting
For this type of mounting, you have to make an
additional cut at the edges of the recess in the
furniture if you wish to install the hob flush with
the countertop.
*Refer to the measurements in the table above.
Hob seal
To prevent leakage of liquid between the frame
of the hob and the countertop, place the
adhesive seal provided along the entire outer
91477A921/A
L
600
C D E
min 50
Y G H
604 514
edge of the hob before assembly.
Do not use silicone to secure the hob.
This would make it impossible to remove
the hob without damaging it.
In the case of flush mounting, after placing the
adhesive seal (A) on the glass surface and after
positioning and securing the hob, fill the edges
with insulating silicone (B) and wipe off any
excess. If for any reason the hob needs to be
removed, cut the silicone using a cutter before
attempting to remove it (C).

Mounting

On top of oven built-in unit
The clearance between the hob and the kitchen
furniture or other installed appliances must be
enough to ensure sufficient ventilation and air
discharge. If installed above an oven, a space
must be left between the bottom of the hob and
INSTALLATION - 35