Mounting - Smeg PGF962 Manual

front and rear sides of the seal must be flush
with the hole.
3. Place the hob on the insulating seal and fix it
to the supporting structure using the screws
and fastening brackets supplied (A) so that
the hob is perfectly level.
4. Carefully trim the excess away from the
edge of the seal (B).
The brackets should be positioned only
after having placed the hob on the seal.
38 - INSTALLATION
Connection positions (mm)
Electrical connection
Gas connection

Mounting

Over built-in oven unit
The clearance between the hob and the kitchen
units or other built-in appliances must be enough
to ensure sufficient ventilation and air discharge.
If installed above an oven, a space must be left
between the bottom of the hob and the top of
the appliance installed below.
1 Opens on bottom
2 Opens on bottom and back
On an empty kitchen
If there are other pieces of furniture under the
hob, a double-layer wooden base must be
installed at least 20 mm from the bottom of the
hob to avoid any accidental contact. It must
only be possible to remove the double-layer
91477A684/B