Table of Contents
Advertisement
with insulating silicone (B) and wipe off any
excess. If for any reason the hob needs to be
removed, cut the silicone using a cutter before
Incasso normale e a filo (mm)
MODELLO (cm)
72
Collegamento elettrico
1. Incasso normale
2. Incasso a filo
Mounting
See General safety instructions.
Over built-in oven unit
The clearance between the hob and the kitchen
units or other built-in appliances must be enough
to ensure sufficient ventilation and air discharge.
If installed above an oven, a space must be left
between the bottom of the hob and the top of
the appliance installed below.
91477B180/A
X
Y
555-560
478-482
attempting to remove it (C).
P
Q
753
513
1 Opens on bottom
2 Opens on bottom and back
It is also necessary to maintain a distance of
approximately 57 mm from the front panel of the
oven to the front of the appliance, as shown in
the figure below.
To ensure proper ventilation, a space of
at least 20 mm must be left between the
bottom of the hob and the oven
underneath.
On an empty kitchen
If there are other pieces of furniture under the
hob, a double-layer wooden base must be
installed at least 20 mm from the bottom of the
F
G
88
317
INSTALLATION - 33
Advertisement
Table of Contents
