Table of Contents
Advertisement
CONFIDENTIAL
3) Vibration resistance: When Packed:
4) Impact resistance:
5) Acoustic noise(Operating):
1.13 Installation
The TM-T88II series printer must be installed horizontally.
(Vibration during paper cutting and using a drawer should be considered. Take measures to
prevent the printer from moving. Affixing tapes are provided as an option.)
An optional hanging bracket can attach the printer to a wall. (Following the procedures
describes in the installation manual, install the wall mount and change the location of the paper
roll near-end sensor, then install the paper roll stopper and other parts.)
No external or internal damage should be found after the
vibration test, and the unit should operate normally.
When Packed:
No external or internal damage should be found after the
drop test, and the unit should operate normally.
When unpacked: Height:
When the printer is not printing, no external or internal damage
should be found after the drop test.
When using auto cutter:
When not using auto cutter:
TITLE
TM-T88 II II II II series
Specification
(STANDARD)
Frequency:
5 to 55 Hz
Acceleration: 2 G
Sweep:
10 minutes (half cycle)
Duration:
1 hour
Directions:
x, y, and z
Package:
EPSON standard package
Height:
50 cm (19.69")
Directions:
1 corner, 3 edges, and 6 surfaces
5 cm (1.97")
Directions:
Lift one edge and release it
(for all 4 edges).
Approximately 55 dB (Bystander position)
Approximately 45 dB (Bystander position)
SHEET
REVISION
D
NO.
SHEET
NEXT
9
10
Advertisement
Table of Contents
