Invacare SB 755 User Manual page 8

Invacare® Soft Tilt
the symbol represented in the zoomed image N. Head facing
towards the head end of the bed and feet towards the foot end
of the bed.
3.
Ensure that the main module is placed in the middle of the
mattress support frame and the distance O, to the side tubes is
the same on both sides.
4.
Cut all the zip ties P to release the wings, and fix the main module
flat with the crossbars of the mattress support. Make sure new zip
ties are placed in the same location when the main module is to be
removed from the bed.
5.
Fix the main module onto the crossbars of the mattress support
frame, by placing the carrige-bolt , trough the designated bracket
on the main module , washer and nut, from underneath on both
sides of the bed.
8
Wiring
The control box and hand control is to be hung at the footboard.
Connections at the control box
• Q Power supply
• R Hand control
• S Right motor
• T Left motor
1.
Run the motor cable underneath the bed frame toward the foot
end (indicated by the arrow in the image), on both sides of the bed
and fix each of the cables with zip ties onto the frame tube. Ensure
that both motor cables are tighten with zip ties (marked by the
circles in the picture), first zip tie near the motor and the last 3 on
the frame tube toward the foot end. Make sure the end of the zip
ties, are not facing outwards from the bed frame.
2.
Connect the hand control to cable R and connect the power cable
Q to the mains. The hand control cable is marked
clip corresponding to on the control box cable.
3
3.
Connect the cables of the right and left motor to the two extension
cables and from the control box. The right motor cable is
S T
marked on the cable clip corresponding to
1
the control box and the left motor cable is marked
on the cable
3
on the cable from
1
on the cable
2
IVCMA755221119