HP 1660 Series Training Manual page 2

Ready, Set, Run:
Easy Steps to Logic Analysis
with the HP 1660/70 Series
Start Here
With the power off, connect Pod 1 of the analyzer to J1 on the
READY
Training Board. For the HP 1660s, Pod 1 is the top cable in the
left-most position when you are facing the rear of the logic analyzer.
For the HP 1670s, Pod 1 is the top cable in the right-most position
when you are facing the rear of the logic analyzer.
1660 Series
Turn on the analyzer by pressing the power switch near the bottom
SET
of the front panel.
The analyzer will take about 15 seconds to boot up.
ii
Get other manuals https://www.bkmanuals.com
1670 Series