Table of Contents
Advertisement
Adjusting Anti-Scalp Rollers
Whenever you change the height-of-cut it is
recommended to adjust the height of the anti-scalp
rollers.
Outer Rollers
1.
Disengage the power take off (PTO) and turn the
ignition key to "OFF" to stop the engine. Move
controllers to neutral locked position and apply
parking brake. Remove the key.
2.
After adjusting height-of-cut remove flange nut
and spring disk while holding stud with wrench
(Fig. 12).
Note:
Do not remove the wheel nut and
washer (Fig. 12).
3.
Select hole so gage wheel is positioned to the
nearest corresponding height-of-cut desired
(Fig. 12).
4.
Reinstall the flange nut and spring disk
(Fig. 12).
5.
Repeat adjustment on other gage wheels.
4
3
2
Figure 12
1. Gage Wheel
2. Stud
3. Spring Disk
1
5
m–4167
4. Flange Nut
5. Wheel nut and washer.
Do Not Remove.
Center Rollers
1.
Disengage the power take off (PTO), turn the
ignition key to "OFF" and remove key. Move
controllers to neutral locked position and apply
parking brake.
2.
After adjusting height-of-cut, remove bolt and
flange nut (Fig. 13).
3.
Select hole so gage wheel is positioned to the
nearest corresponding height-of-cut desired
(Fig. 13).
Note:
Do not adjust rollers to support the
deck.
4.
Reinstall the bolt, center rollers and flange nut
(Fig. 13).
3
1
Figure 13
1. Center Rollers and Spacer
2. Flange Nut
Operation
2
m–4124
3. Bolt
29
Advertisement
Table of Contents
