Install Motion Control Levers - Toro 74211-990001 Operator's Manual

Install Motion Control Levers

1. Remove the (4) 3/8–16 x 1" (26 mm) bolts and
(4) 3/8" spring washers which attach the motion
control levers to the control arm shafts for
shipping (Fig. 3).
2. Place the levers (with the mounting plate toward
the rear) on the outside of the control arm shaft
and secure with (4) 3/8–16 x 1" (26 mm) bolts
and (4) 3/8" spring washers (Fig. 3).
3. Position the levers so the bolts are in the center
of the slots on the lever mounting plate and
tighten until snug.
4. Align the front\rear position of the levers, with
each other, in the neutral position. Loosen
hardware and adjustment by sliding/tilting the
lever(s) forward or backward until properly
aligned(Fig. 3).
2
3
Figure 3
1. Mounting plate
2. Bolt 3/8–18 x 1" (26 mm)
1
m–3751
3. Spring washer 3/8"
5. If the ends of the levers hit against each other,
while in the drive position (Fig 4) (levers rotated
in as far as possible) make adjustments by
moving the levers outward to the neutral lock
position and carefully bend them outward. Move
them back to the drive position and check for
clearance. Repeat if necessary.
Figure 4
Assembly
17