Table of Contents
Advertisement
Stopping
1.
Move the throttle lever to "SLOW" (Fig. 5).
2.
Turn the ignition key to "OFF" and remove
(Fig. 6).
Note:
If the engine has been working hard or
is hot, let it idle for a minute before
turning the ignition key "OFF." This
helps cool the engine before it is
stopped. In an emergency, the engine
may be stopped by turning the ignition
key to "OFF."
3.
Pull wire off spark plug(s) to prevent possibility
of someone accidentally starting the machine
before transporting or storing machine.
4.
Close fuel shut off valve, on front panel before
transporting or storing machine.
IMPORTANT: Make sure fuel shut off valve
is closed before transporting or storing
machine, as fuel leakage may occur. Set
parking brake before transporting. Make
sure to remove key as fuel pump may run and
cause battery to lose charge.
POTENTIAL HAZARD
Someone could move or attempt to operate
the tractor while it is unattended.
Fuel pump could stay operating.
WHAT CAN HAPPEN
Children or bystanders may be injured if
they use the tractor.
Fuel leakage could occur if there is a leak in
fuel line.
HOW TO AVOID THE HAZARD
Always remove the ignition key and set the
parking brake when leaving the machine,
even if just for a few minutes.
Operating the Power Take Off
(PTO)
The power take off (PTO) switch engages and
disengages power to the electric clutch.
Engaging the PTO
1.
Release pressure on the traction control levers
and place in neutral.
2.
Release the parking brake, page 24.
3.
Pull out on the power take off (PTO) switch to
engage (Fig. 7).
1
Figure 7
1. PTO – Off
Disengaging the PTO
1.
To disengage push the PTO switch to the "OFF"
position (Fig. 7).
Operation
2
m–4201
2. PTO – On
25
Advertisement
Table of Contents
