Replacing The Deck Belt; Replacing The Pto Drive Belt - Toro 74211-990001 Operator's Manual

Liquid cooled with 52” sfs side discharge mower
Table of Contents

Advertisement

Replacing the Deck Belt

Squealing when the belt is rotating, blades slipping
when cutting grass, frayed belt edges, burn marks and
cracks are signs of a worn deck belt. Replace the deck
belt if any of these conditions are evident.
1.
Stop the engine, set the parking brake, remove
the key and disconnect the spark plug wire(s)
from the spark plug(s).
2.
Remove the PTO drive belt. Refer to Replacing
the PTO Drive Belt, on page 57.
3.
Remove idler spring from idler arm, then remove
the worn deck belt (Fig. 49).
4.
Install the new deck belt around the spindle
pulleys, belt guide, the idler pulley, and in the
lower groove of the center spindle pulley
(Fig. 49).
5.
Using a socket and torque wrench, rotate the
idler adjusting nut until torque is 25–30 ft.–lb.
(34–41 N m). Tighten two nuts.
Figure 49
Top View
1. Deck Belt
2. Idler Arm
6.
Reinstall the PTO drive belt. Refer to Replacing
the PTO Drive Belt, page 57.
1
3
4
2
m–3890
3. Belt guide
4. Idler Spring

Replacing the PTO Drive Belt

Squealing when the belt is rotating, blades slipping
when cutting grass, frayed belt edges, burn marks and
cracks are signs of a worn drive belt. Replace the
PTO drive belt if any of these conditions are evident.
1.
Stop the engine, set the parking brake, remove
the key and disconnect the spark plug wire(s)
from the spark plug(s).
2.
Remove the clutch retaining strap from machine
frame and unplug clutch terminal from wire
harness (Fig. 50).
3.
Remove the PTO drive belt (Fig. 50).
4.
Place new PTO drive belt over clutch, around
rear idler pulleys and onto mower top center
pulley.
Note:
Check that belt has only 1/4 twist
between each pulley and idler.
5.
Install clutch retaining strap and plug clutch
terminal into main wire harness (Fig. 50).
4
m–3748
1
Figure 50
1. Clutch
2. Clutch retaining strap
3. clutch Terminal
6.
Check belt tension. The center bolt of spring
loaded idler must be between the two alignment
holes in left support plate (Fig 51).
Maintenance
5
3
2
4. PTO belt
5. Machine Frame
57

Advertisement

Table of Contents
loading

This manual is also suitable for:

Z-master z252lZ-master 250 series

Table of Contents