National Instruments NI PXI-8104 User Manual page 55

Caution Do not leave the jumper on pins 2–3. Doing so decreases battery life. Also, the
controller will not boot.
1 Normal Operation (Default)
© National Instruments Corporation
As an alternative method, complete the following steps:
1. Power off the chassis.
2. Remove the controller from the chassis.
3. Move the jumper on W7 from pins 1–2 to pins 2–3 as shown in
Figure 5-1.
4. Wait one second. Move the jumper back to pins 1–2.
5. Reinstall the controller in the chassis.
2 Clear CMOS Contents
Figure 5-1. Clearing the CMOS Contents
3
1
5-3
Chapter 5 Troubleshooting
2
3 Pin 1
NI PXI-8104 User Manual