Table of Contents
Advertisement
Chapter 2
Installation and Configuration
How to Remove the Controller from the PXI Chassis
NI PXI-8104 User Manual
Figure 2-2 shows an NI PXI-8104 installed in the system controller slot of
a National Instruments PXI-1042 chassis. You can place PXI devices in any
other slots.
1
2
1 PXI-1042 Chassis
Figure 2-2. NI PXI-8104 Controller Installed in a PXI Chassis
The NI PXI-8104 controller is designed for easy handling. To remove the
unit from the PXI chassis, complete the following steps:
1.
Power off the chassis.
2.
Remove any cables that may be attached to the controller front panel.
3.
Unscrew the bracket-retaining screws in the front panel. Refer to
Figure 2-1 for the location of these screws.
4.
Press the injector/ejector handle down.
5.
Slide the unit out of the chassis.
3
2 NI PXI-8104 Controller
2-4
3 Injector/Ejector Rail
ni.com
Advertisement
Table of Contents
