Chapter 2
Installation and Configuration
Caution
Do not leave the jumper on pins 2–3. Doing so decreases battery life. In addition,
leaving the jumper on the pins prevents the controller from booting.
1
Normal Operation (Default)
LabVIEW RT Installation
LabVIEW RT Software Installation
NI PXI-8104 User Manual
2 Clear CMOS Contents
Figure 2-3. Clearing the CMOS Contents
This section explains software installation and switch configuration for
LabVIEW RT on your PXI controller.
The following section describes the necessary steps to get your PXI
embedded controller setup to run LabVIEW Real-Time. In this section you
will configure the boot mode of the controller, verify or change IP settings,
and install LabVIEW Real-Time software.
3
1
2-12
2
3 Pin 1
ni.com