Table of Contents
Advertisement
Installation and Configuration
Installing the NI PXI-8104
Caution
To protect both yourself and the chassis from electrical hazards, leave the chassis
powered off until you finish installing the NI PXI-8104 module.
© National Instruments Corporation
This chapter contains information about installing and configuring your
NI PXI-8104 controller.
This section contains general installation instructions for the NI PXI-8104.
Consult your PXI chassis user manual for specific instructions and
warnings.
1.
Plug in your chassis before installing the NI PXI-8104. The power
cord grounds the chassis and protects it from electrical damage while
you install the module. (Make sure the power switch is turned off.)
2.
Remove any filler panels blocking access to the system controller slot
(Slot 1) in the chassis.
3.
Touch the metal part of the case to discharge any static electricity that
might be on your clothes or body.
2-1
2
NI PXI-8104 User Manual
Advertisement
Table of Contents
