National Instruments NI PXI-8104 User Manual page 21

Caution
Changing settings in this menu may result in an unstable or unbootable controller.
If this happens, follow the procedures outlined in the
BIOS settings to their factory defaults.
© National Instruments Corporation
The Advanced setup menu includes the following settings:
• Reset Configuration Data—A portion of the EEPROM on the
controller is designated as the Extended System Configuration Data
region (ESCD). The BIOS and Plug-and-Play operating systems use
this table to store the Last Known Good configuration of system
peripherals. If you experience resource conflicts or peripheral
malfunction, set this setting to Yes to force the BIOS to recreate the
ESCD on the next reboot. This is rarely necessary.
• Integrated Peripherals—Use this setting to bring up the Integrated
Peripherals submenu. (Refer to the Integrated Peripherals Submenu
section.)
• Quick Boot Mode—When you enable this option, certain lengthy
BIOS tests that rarely fail are skipped to shorten controller boot time.
The default is Enabled.
Summary Screen—This setting controls the display of the summary
•
screen shown after BIOS completes its initialization, but before
booting takes place. You can disable this screen in the interest of
shortening controller boot time. The default is Disabled.
PXE Network Boot—This setting enables the option for booting from
•
a network PXE server on the subnet. The default is Disabled.
Integrated Peripherals Submenu
Use this submenu to apply nondefault configurations to the front panel
peripherals of an NI PXI-8104 controller. Normally, you do not need
to modify these settings, as the factory default settings provide the most
compatible and optimal configuration possible.
• Serial Port A—This setting enables or disables COM1. You also can
change this setting to Enabled and modify the base address and
Interrupt Request Level (IRQ) of a port. The default is Auto, which
places COM1 at 0x3F8 IRQ 4.
• Parallel Port—Use this setting to enable or disable LPT1. You also
can change this setting to Enabled and modify the base address,
IRQ level, and ISA Direct Memory Access (DMA) channel of the
port. The default is Auto, which places LPT1 at 0x378, IRQ 7, using
ISA DMA Channel 3 if necessary.
Chapter 2
System CMOS
2-7
Installation and Configuration
section to restore
NI PXI-8104 User Manual